Author Topic: Questions Part 42 (part a)  (Read 2327 times)

admin

  • Full Member
  • ***
  • Posts: 127
Questions Part 42 (part a)
« on: August 30, 2009, 08:28:05 AM »
Founding RN



Joined: 10 Jan 2003
Posts: 172

   
PostPosted: 10 Jan 2003 15:00    Post subject: Educational Questions, Part 42    

To our Readers and Posters,<
>The best defense in any fight against a disease is education. <
>This column of questions and answers is an attempt in that direction. Anyone is welcome to ask questions. <
><
> What I want to reiterate again is that my answers to your questions DO NOT and SHOULD NEVER take the place of your Dr.'s advice. I am not a Dr. and my answers are based on my many years of experience in the dialysis field. What works for one patient may not work for another. EVERY Patient needs to schedule and attend regular visits with your Dr. in their office.<
><
>This column is for dialysis and dialysis related questions. Please be aware that clinics and companies, machines, policies and procedures vary from place to place. <
><
>I hope that we can help in furthering your dialysis education.

>Thank you!<
>Founding RN <
><
>P.S. I work full time so I may not be able to answer your questions right away. But I will get to them ASAP!<
>

*********************************************
    
patient



Joined: 30 Oct 2002
Posts: 137

   
PostPosted: 19 Jan 2003 05:00    Post subject: Sticking    Reply with quote Edit/Delete this post Delete this post View IP address of poster
Hi FRN,<
>I have a question about sticking. I have had an upper arm fistula for about 3 years. In my current unit, things have gone very well, no problems in the sticking dept. A tech who got her training elsewhere told me I should have the techs start a new track on either side of my current track as its wearing thin she says. I would be hesitant to get that started as I don't know if my techs have the ability to start new tracks. I always have my sites rotated, but I have never heard of sticking to the sides of the main track. Is this good sticking procedure? Thanks and congratulations on your newest board.

*********************************************        
Kelli



Joined: 19 Jan 2003
Posts: 3

   
PostPosted: 19 Jan 2003 05:08    Post subject: Labs    Reply with quote Edit/Delete this post Delete this post View IP address of poster
Last month my KT/V was 1.88 and my URR was 80. I dialyze 4 hours 3xweek. This month my KT/V is 2.58 and my URR is 78. Can you tell me the significance of these numbers and are the KT/V and URR independent of each other since my KT/V rose, but my URR didn't rise?


*********************************************   
patient



Joined: 30 Oct 2002
Posts: 137

   
PostPosted: 19 Jan 2003 19:25    Post subject: Chicken Soup & Pickle Juice    

I read where one unit told an elderly patient to drink pickle juice for low bp. When I have had low bp the last thing I want is something salty to drink. That would drive me crazy and I'd become so thristy I might go off the wagon craving water. When I have had low bp I got very thristy and I just drank a little water, and went home and slept it off. Is chicken soup or pickle juice a sane suggestion? I realize its to
ing the bp up, but surely there's a better way. <
><
>Also, why does sodium
ing the bp up when too much sodium may be what
ought it down in the first place and leads to cramping too?

*********************************************    
ridgerunner



Joined: 12 Jan 2003
Posts: 101

   
PostPosted: 19 Jan 2003 21:59    Post subject: labs and clearance    

ktover v and urea clearance.mean nothing. the important things are creatinine phosphorus are you taking binders do you have diet restrictions do you have to take blood pressure meds. if you are getting proper treatment you will not need to take these meds. the system of measuring clearance was set up by yhe corps in order to cut treatment time. they mean nothing. they increased the death rate from about 8 to 10 percent to about 23 percent short speed dialysis kills. the only solution is to go back to the way they did it in the beginning long slow treatment and this can only be done with self care and home care for the ones who are able.

*********************************************        
Founding RN



Joined: 10 Jan 2003
Posts: 172

   
PostPosted: 19 Jan 2003 23:13    Post subject: Patient    

It is an option if you have built up lots of scar tissue. I have used this method on many patients and it can extend the life of your access. It gives the skin on the top of your access a rest and doesn't hurt the access. I have had a few patients say that occassionally they had a bit of discomfort because of the angle, but that it was tolerable. Try it and see what you think but be sure that the person who sticks you is someone you trust to do it right.

*********************************************        
Founding RN



Joined: 10 Jan 2003
Posts: 172

   
PostPosted: 19 Jan 2003 23:18    Post subject: Kelli    

This is not an easy topic to explain and there are times I even am not sure that I totally understand it. I went on-line and did some searching and this is what I came up with. It explains it better that I think I could, even though it is rather long. I do have to agree with Ridgerunner though, how you feel is really the best way to evaluate your treatment. But this is something you can use as a guideline to help you in your evaluation. <
><
><
><
>To see if dialysis treatments are removing enough urea, the clinic should periodically--normally once a month--test a patient's blood to measure dialysis adequacy. Blood is sampled at the start of dialysis and at the end. The levels of urea in the blood in the two samples are then compared. There are two methods to assess dialysis adequacy in general use, URR and Kt/V. <
><
><
>What Is the URR?<
>The percent reduction in urea as a result of dialysis, or the URR (this stands for urea reduction ratio, although it is commonly expressed as a percent), is one measure of how effectively a dialysis treatment removed waste products from the body. <
>Example: If the initial (predialysis) urea level was 50 mg/dL, and the postdialysis urea level was 15 mg/dL, the URR is computed as 100 x (initial level - postdialysis level)<
><
>--------------------------------------------------------------------------------<
>(initial level) = 100 x (50 - 15)<
><
>--------------------------------------------------------------------------------<
>50 = 70% <
>Although there is no fixed number that represents an adequate dialysis, it has been shown that patients generally live longer and have fewer hospitalizations if the URR is at least 60 percent. For this reason, some groups advising on national standards have recommended a minimum URR of 65 percent.<
><
>The URR is usually measured only once every 12 to 14 treatments (i.e., once a month). It may vary considerably from treatment to treatment. For this reason, a single value that is below 65 percent should not be of great concern, but on average, the URR should exceed 65 percent.<
><
><
>What Is the Kt/V?<
>Another way of measuring dialysis adequacy is the Kt/V. In this measurement, K stands for the dialyzer clearance, expressed in milliliters per minute (mL/min), and the small t stands for time. Kt, then, is clearance multiplied by time. This top part of the fraction represents the volume of fluid completely cleared of urea during a single treatment. If the dialyzer's clearance is 300 mL/min and a dialysis session lasts for 180 minutes (3 hours), Kt will be 300 mL/min x 180 min. This equals 54,000 milliliters, or 54 liters. <
>In the bottom part of the fraction, V is the volume of water a patient's body contains. The body is about 60 percent water by weight. If a patient weighs 70 kilograms (154 lbs), V will be 42 liters. So the ratio (K x t) to V, or Kt/V, compares the amount of fluid that passes through the dialyzer with the amount of fluid in the patient's body. The Kt/V for this patient would be 54/42, or 1.3.<
><
>The Kt/V is mathematically related to the URR and is in fact derived from it, except that the Kt/V also takes into account two additional factors: (1) urea generated by the body during dialysis and (2) the extra urea removed during dialysis along with excess fluid. <
><
>The Kt/V is a more accurate way than the URR to measure how much urea is removed during dialysis, primarily because the Kt/V also considers the amount of urea removed with excess fluid. Consider two patients with the same URR and the same postdialysis weight, one with a weight loss of 1 kg during the treatment and the other with a weight loss of 3 kg. The patient from whom 3 kg are removed will have a higher Kt/V, even though both have the same URR. <
><
>This does not mean that it is better to gain more water weight between dialysis sessions so that more fluid has to

 be removed, since this has bad effects on the heart and circulation. However, patients who have higher weight loss during dialysis will have a higher Kt/V for the same level of URR. <
><
><
>How Does the Kt/V Compare with the URR? <
>On average, a Kt/V of 1.2 is roughly equivalent to a URR of about 63 percent. For this reason, another standard of adequate dialysis is a minimum Kt/V of 1.2. This is the new standard adopted by the Dialysis Outcomes Quality Initiative (DOQI) group. Like the URR, the Kt/V may vary considerably from treatment to treatment because of measurement error and other factors. So while a single low value is not always of concern, the average Kt/V should be at least 1.2. In some patients with large fluid losses during dialysis, the Kt/V can be greater than 1.2 with a URR slightly below 65 percent (in the range of 58 percent to 65 percent). In such cases, the Kt/V is considered to be the primary measure of adequacy by the DOQI guidelines. <
><
>Is a Kt/V of 1.2 Good Enough?<
>These numbers?a URR of 65 percent and a Kt/V of 1.2?have been determined to be benchmarks of dialysis adequacy on the basis of studies in large groups of patients. These studies generally showed that patients with lower Kt/V and/or URR numbers had more health problems and a greater risk of death. <
>One large study funded by the National Institutes of Health is testing whether a Kt/V of about 1.6 or 1.7 (and a URR of about 75 percent) results in even better patient outcomes. We should have the answer within the next 2 to 3 years. <
><
><
>What Should You Do if Your Kt/V Is Below 1.2 or if Your URR Is Below 65 Percent?<
>If your Kt/V is always above 1.2 and your URR is close to 65 percent (it may be a few points lower if you have large fluid losses during dialysis), then your treatment is meeting adequacy guidelines.<
><
>If your average Kt/V (usually the average of three measurements) is consistently below 1.2, then you and your nephrologist need to discuss ways to improve your Kt/V. Since the V value is fixed (it represents your total body water volume), Kt/V can be improved either by increasing K (clearance) or t (session length). To increase t, you need to dialyze for a longer period. For example, if your Kt/V is 0.9 and you want to go up to 1.2, then you need 1.2/0.9 = 1.33 times more Kt. If K is not changed, this means that your session length needs to be increased by 33 percent. If your session time is 3 hours, it should be increased to 4 hours.<
>Another way to improve the Kt in Kt/V is to increase K, the dialyzer clearance, which depends primarily on the rate of blood flow through the dialyzer. No matter how good a dialyzer you have, how well it works depends primarily on moving blood through it. In many patients, a good rate is difficult to achieve because of access problems.<
><
>If your blood flow rate is good (it should be at least 350 mL/min for adult patients, and preferably higher), you can get further improvements in clearance by making sure that you use a big dialyzer or, in some cases, by increasing the dialysate flow rate from the usual 500 mL/min to 600 or 800 mL/min. A few centers are even using two dialyzers at the same time to increase K in large patients. <
><
>However, the rate of blood flow through the dialyzer is key, and a good vascular access is very important to make sure that you are getting good clearance.<
><
><
>If during any given month your Kt/V is very low, the measurement should be repeated, unless there was an obvious reason for the low Kt/V (e.g., treatment interruption, problems with blood or dialysate flow, some problem in sampling either the pre- or postdialysis blood). If there is no clear-cut reason for the sudden drop, then a problem with needle placement (inadvertent needle reversal) or with the vascular access (recirculation) should be suspected.
« Last Edit: August 30, 2009, 12:11:33 PM by Administrator »
"Like me, you could.....be unfortunate enough to stumble upon a silent war. The trouble is that once you see it, you can't unsee it. And once you've seen it, keeping quiet, saying nothing,becomes as political an act as speaking out. Either way, you're accountable."

Arundhati Roy